- Store
- >
- Parts and Accessories
- >
- Handles & Controls
- >
- Billet Paddle Throttle with Cable and Grip + Tube Diameter Adapter
Billet Paddle Throttle with Cable and Grip + Tube Diameter Adapter
SKU:
$79.00
$79.00
Unavailable
per item
This Billet Aluminum throttle with cast plastic paddle is made to fit on handles with a 7/8" OD. The tube adapter is 7/8" and will slide in to Backwater handles that are 1 1/8" OD or any handle with a 7/8" ID. Designed to have a long cable travel to give full RMP range on mud motor engines (off-the-shelf brake levers usually do not have long enough pull). Two set screws hold this securely in place and even comes with a grip to make installation very easy. These Billet throttles look great, perform great and are super durable. Includes the Magura handle grip as well.
The tube adapter is 7/8" and will slide in to Backwater handles that are 1 1/8" OD or any handle with a 7/8" ID. The tube adapter can be bolted in place. When bolting on apply silicon caulking before sliding in to prevent vibration. Welding the tube adapter in place is best, silicon is not needed. Note that the handle length is going to get longer if the current handle is not cut down before installing. To keep the handle length the same as it was cut the handle shorter by the amount the tube adapter is going to increase the length.
The tube adapter is 7/8" and will slide in to Backwater handles that are 1 1/8" OD or any handle with a 7/8" ID. The tube adapter can be bolted in place. When bolting on apply silicon caulking before sliding in to prevent vibration. Welding the tube adapter in place is best, silicon is not needed. Note that the handle length is going to get longer if the current handle is not cut down before installing. To keep the handle length the same as it was cut the handle shorter by the amount the tube adapter is going to increase the length.