Complete bearing system kit
SKU:
$300.00
$300.00
per item
Complete Bearings System Kit. This kit comes with the upper and lower weld-on threaded bearing housing couplers (weldments). Upper and lower bearing housings with sealed bearings installed and upper and lower bearing housing caps that hold two seals on top and bottom. All threads on lower bearing system are left hand to prevent loosening due to shaft rotation. All threads on upper bearing system are right hand to prevent loosening due to shaft rotation.
*There are two options for the threaded weld-on bearing housing couplers (weldments). Choose correct one at check out.
-DOM Tube Build - These weldments are made for 1 3/8" 12 Gauge DOM tube. The OD is 1 3/8 inches and ID is 1.157 inches and the wall thickness is 0.109". The upper bearing housing weldment slides over tube with an OD of 1 3/8 inches. The lower bearing housing weldment slides inside tube with an ID of 1.157 inches. This is the better choice of tube if you are starting a build from scratch.
-RETRO-FIT old motor frame or WATER PIPE build - This kits has weldments that are made to fit pipe with an OD of 1.32 inches and an ID of 1 inch. The upper bearing housing weldment slides over pipe with an OD of 1.32 inch. The lower bearing housing weldment fits inside of the pipe with a 1 inch ID. This is often the correct weldment if water pipe is being used or if the kit is being used to retro-fit an old motor with new bearing system.
* Note: This kit does not have the Revo-Clean feature.
Standard Ground Shipping in U.S. is $15
*There are two options for the threaded weld-on bearing housing couplers (weldments). Choose correct one at check out.
-DOM Tube Build - These weldments are made for 1 3/8" 12 Gauge DOM tube. The OD is 1 3/8 inches and ID is 1.157 inches and the wall thickness is 0.109". The upper bearing housing weldment slides over tube with an OD of 1 3/8 inches. The lower bearing housing weldment slides inside tube with an ID of 1.157 inches. This is the better choice of tube if you are starting a build from scratch.
-RETRO-FIT old motor frame or WATER PIPE build - This kits has weldments that are made to fit pipe with an OD of 1.32 inches and an ID of 1 inch. The upper bearing housing weldment slides over pipe with an OD of 1.32 inch. The lower bearing housing weldment fits inside of the pipe with a 1 inch ID. This is often the correct weldment if water pipe is being used or if the kit is being used to retro-fit an old motor with new bearing system.
* Note: This kit does not have the Revo-Clean feature.
Standard Ground Shipping in U.S. is $15
