Aluminum floatation pods - Large Set (2 pods) About a two week lead to ship after ordering
Attention: Our online store is currently not able to calculate shipping to Alaska, Hawaii and other U.S. territories for pods orders. If you are outside the lower 48, please call us if you are interested pods and we will gladly help you out!
Note: When ordering, you only need to select a quantity of 1 to get a pair of pods
High quality made in the USA pods. Reduce draft and get on plane faster. Pods are to be welded or bolted to stern of the boat.
Large – Fits 15 to 20ft boats with width 52" or more Pod width: 21-1/2"
Large pods are 17 inches wide at the bottom. The outside walls of the pods are angled to match the angle of most jon boat gunnel walls. When Large pods are installed on a 1860 jon boat (60 inches wide at the bottom) the open space in between the pods should be close to 26 inches. The large pods provide about 182 pounds of lift when fully submerged.
These pods are ideally designed to be welded onto the boat. The drain plug in the pod should be taken out during welding to prevent welds from blowing out.
Bolting the pods on is also an option. The customer will have to cut a hole in the top of the pod to gain access. Then bolt through the transom with a minimum of 4 bolts, one in each corner. Fender washers should be used on both sides and silicon caulking used to seal bolts. A piece of aluminum larger than the access hole should be used to seal the top. This can be welded, or caulked and screwed on.
How close will the sides of the pods match my gunnel wall?
The angle of the outer wall of each pod is equal to a vertical rise of 8" and horizontal run of 4 3/4". If you measure the rise and run of your gunnel walls at the transom you can get a good idea of how closely the pods will match.
What is the pod width at the bottom?
Small pods are 11" wide at the bottom
Mediums pods are 14" wide at the bottom.
Large pods are 17" wide at the bottom.
How much room will I have between the pods.
To see how much room will be in between the pods on your boat you will want to take all measurements on the bottom of the boat at your transom.
From the bottom corner on each side, measure towards the center and make a mark at width of each pods.